Interior Finishing Putty «FINLAND» TM TRIORA active (Копия) (Копия) - IE ZIP LLC preloader
Показать категории
Показать фильтры товаров

Interior Finishing Putty «FINLAND» TM TRIORA active (Копия) (Копия)

    • Type of works

      Interior, Exterior

    • Coverage

      1,6 kg/м² for 1 mm layer thickness

    • Thinner


    • Drying time

      4-12 hours at +18-22 °С and 65% RH

    • Containers

      0,8 kg, 1,5 kg, 16 kg, 5 kg

    • Drying time

      24 months


Value of the product

  • White after drying
  • Filling material – calcium carbonate
  • Layer falls to 3 mm without cracking
  • It can be used as filler as the starting and finishing for alignment
  • Easy to application
  • Easy to sand
  • Can be applied by airless spray

Recommended uses:
For partial and complete surface puttying, for levelling of minor roughness and defects of up to 3 mm before applying finishing coating inside premises (painting, decorative plasters, wallpapers, etc.).
Application guidelines
Surface preparation
The surface should be clean, dry, solid and degreased. The surfaces that were previously covered with chalk, glue, lime or organosilicone paints should be cleaned up to complete removal of the old coating. If there is mould or fungi on the surface, use TRIORA prof  Bioprotective Agent “TR-25 bio” to remove them. To ensure proper surface preparation, extend operational life of the coating and reduce paint consumption, the surface should be previously treated with TRIORA active CHILE Acrylic Primer or PERU Priming Concentrate. Highly absorptive (aerocrete, gypsum) and peeling surfaces should be primed with TRIORA prof Reinforcing Deep Penetration Primer “TR-23 strong”. Major roughness and fractures should be levelled with TRIORA prof Water-resistant Acrylic Putty «TR-12 power».

No dilution needed.

Application guidelines
The putty is to be applied with a putty knife or a sprayer with up to 0,3-0,5 mm layer thickness. Before final finishing, the puttied surface must be polished with fine sandpaper.

ATTENTION! Not to be used on surfaces which are under continuous exposure of water, in places with increased humidity. In these cases, TRIORA Facade Putty is recommended.
Safety precautions
Keep away from children. If you are splashed in the eyes, flood them immediately with fresh water.

Keep and transport in a tightly closed original container, at temperature +5 °С – +35 °С. Keep away from heat and direct sunlight. Protect from freezing! Closed containers with remaining product shall be disposed of at designated recycling collection points.

[vfb id='13']
[vfb id='10']